![]() ![]() I had to phisically open up my control pannel and switch my joystick 180 degrees. ![]() The problem i was having earlier was that when i hit UP. ****Take note**** I could not re-map my joystick. Now take your key map that your wrote down earlier, and map the start, coin, sword (button 1 i think) to what buttons you want. KEY_COIN1 = 53( Download PAL version (876 MB) (640 x 480 - 23. There you will see this in the text file and this is where you have to map your buttons you wrote down: Publication date Topics Dragon's Lair, Dragon's Lair, Daphne, Emulator Dragon's Lair (1983) & 'Daphne' Emulator Original arcade coin operated version. You are going to want to naviagte through all these folders as follows: You should see 4 different folders: Bios, Configs, Roms, Splashscreens. So you have to set that up or find a hard wire way to get into the file system for the next step. I am running Mac OS and have my rasp-pi set up on my internet network. I made a chart with my button layout and wrote down each buttons number when i pressed it. When you run that script, every time you hit a button, you should be able to see what number that button is mapped to. Wolfanoz 32 arcade image.Ä®xit Emulation station to get to your Dos style looking bootup screen and type in this.įind the button you want to map by running: Preface:Retroarch controls do not work for daphne so you can't just map it like you normally would with other systems. You are correct in thinking that Daphne does not use the retroarch core for input mapping. Coin 2, start, all the skill select buttons, service, test and reset buttons are set to âNothing.â Finding the ID number of each of the buttons and then correcting the config file should fix your issues. Likewise, left, right and button 1 are all set to the same input as well. In your config up, down, and button 2 are all mapped to the same input. ![]() When I get back home I can post my working config file, but unless your encoder is listed and set up the same as my 8bitdo controller it will likely be different. I am also able to play with my 8bitdo joystick. My personal config is a bit simpler since the iPac encoder is seen as a keyboard. Running something like jstest from a command line to find what button is what will help. You have to figure out what the button ID numbers are interpreted as in your system. Looking at your config for the joystick inputs ( the last set of numbers) there are multiple duplicates. I have been using Daphne for over 10 years. I have not plugged my pi into my A1Up cab yet. I have Daphne running off a raspberry pi that uses an iPac as its encoder. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |